*Il prezzo si intende IVA inclusa
Descrizione
Fearture:
ÂœLarge-sized high efficiency heatsink makes the ESC stable under large current output.
œ5-6V step-less adjustable BEC output allowing custom voltage setting to match servo specification.
ÂœBEC output utilizing switching power system, suitable for 7.4-22.2V (2s-6s) Li battery, with continuous current
rating of 3A, and burst rating of 5A.
ÂœThree programmable throttle speed settings to support quick throttle response.
ÂœInclude soft start and governor mode.
ÂœSmall and compact PCB design for lightweight and simple installation.
ÂœLarge heat sink for optimum thermal performance.
ÂœHighly compatible to work with 98% of all brushless motors currently on the market.
ÂœUltra-smooth motor start designed to run with all kinds of brushless motors.
ÂœThe power inlet utilizes a Japanese made "Low ESR" capacitor in order to provide stable power source.
ÂœThe throttle has more than 200 step resolution that provides great throttle response and control.
ÂœIf the aircraft should land or crash in an unexpected location and become lost, the pilot can enable the Aircraft Locator Option. The Aircraft Locator Option is engaged by tuming off the transmitter. When the ESC does not receive a signal from the transmitter for 30 seconds, it will start to send an alarm to the motor. The sound of the alarm will aid the pilot to locate the aircraft. This option will not work with a PCM receiver that has SAVE function enabled, or with low noise resistant PM receivers. ÂœContimuous current:70Amps with porper air flow
ÂœSurge current:110Amps(5sec)
ÂœSupporting motor types:2~10 pole in/outrunner brushless motors.
ÂœSupporting maximum RPM:2poles=>190,000rpm;6poles=>63,000rpm
ÂœSupporting input voltage:5.5V~25.2V
ÂœSupporting battery types: Li-ion/ Li-poly 2~6 cells
ÂœBEC output voltage: 5-6V step-less adjustment
ÂœContinuous current 3A; Burst current 5A
ÂœSize:65X31X18mm
ÂœWeight:72g
NOTE:
1.When setting to the Quick response speed, theacclerative peak current will increase.
2.To minimize possible radio interference induced by switching power system, BEC should be installed at least 5cm away from the receiver.The use of PCM receiver is recmmonded
Torna alla homepage
|
